6/30/87
BRIEF Instructions For Using ScanEdit+:
===== ============ === ===== ==========
IMPORTANT: SCANEDIT MUST be named SCANEDIT.ACC, and STSCAN MUST be named
STSCAN.PRG in order to function properly together.
SCANEDIT will only work with version 1.2e or later of STSCAN.
SETUP:
Copy SCANEDIT.ACC to your boot disk into the top (or ROOT) folder on
the disk. Reboot system, then run STSCAN. After scanning a window,
you may select ScanEdit+ from the Desk menu. Scanedit will open a
window on the image you have scanned.
MAGNIFICATION:
Initially, ScanEdit+ will be in 1x magnify mode, the image appearing
similar to that available in STScan. By clicking on the FULL box in
the upper right corner, ScanEdit+ will then be set to 8x magnification
mode, providing you with an enlarged image for precise editing.
Clicking again in the FULL box in the upper right corner will return
you to the 1x magnification mode.
EDITING:
Clicking the left mouse button anywhere inside the ScanEdit+ window
will toggle the pixel under the cursor. This also determines the
mode ScanEdit+ uses while the mouse button is held down. For instance,
if you click on a dark pixel, it will be erased. If you then hold down
the mouse button, any pixels under the cursor will be erased.
After you let go of the left mouse button, the main STScan window will
be updated to show the results of your editing.
*EOF:readme